← Blog

Tab by tab

Tab by tab: View

This series goes through the editor one tab at a time and says, button by button, what each one does. After Home and Layout, it is the turn of View.

View is about how you see and place your work: rulers and guides to measure with, a grid to count on, snapping to put things exactly where they belong, and a way to look past the colours at the bare paths. None of it ever ends up in an export or a print. Guides, the grid and Xray are there for you only.

Rulers and guides

  • Rulers - shows rulers along the top and the left edge of the canvas, marked in the units chosen on the Layout tab.
  • Guides - shows or hides the guides. A hidden guide does not snap either.
  • Clear - deletes every guide in the document at once. Ctrl + Z brings them back.
  • Lock - locks the guides, so they cannot be selected or moved by accident. Click it again to unlock them.
  • Angle - turns the selected guide to any angle between -90° and 90°.

To make a guide, turn the rulers on, press on the top ruler and drag down for a horizontal guide, or drag from the left ruler for a vertical one. Then, with the Select tool:

  • click a guide to select it, and it turns red;
  • drag it to move it;
  • press Del to delete it, or simply drag it back onto a ruler;
  • drag the small round handle of a selected guide to turn it, and hold Shift to turn it in steps of 15°.

Guides belong to the whole document, so a guide you place shows on every page.

Grid

  • Show - draws a grid over the page, with every fifth line a little stronger.
  • Size - the distance between the grid lines, in pixels. It stays in pixels whichever unit you work in.

Snap

Snapping pulls whatever you draw or drag onto an exact spot as soon as you come close to it.

  • To Grid - onto the grid lines, at the grid size. It works even while the grid itself is hidden.
  • To Pixel - onto whole pixels, for crisp edges in screen graphics. To Grid and To Pixel exclude each other: turning one on turns the other off.
  • To Guide - onto the guides, turned guides included, as long as the guides are visible.
  • To Object - onto the nodes, corners, centres and quadrants of other objects, so a line can start exactly on the corner of a rectangle. A small marker flashes on the point it caught.
  • Smart - smart guides: while you move an object, it lines up with the edges and centres of the objects around it, and a line shows what it is lined up with.

When a node or a corner of another object is within reach, To Object wins over guides and the grid, because it is the most precise target there is.

Display

  • Xray - shows every object as a thin outline, with no fills, colours or shadows. It is handy for finding a path hidden under another, or for checking the lines a cutter or a plotter will follow. Only the screen changes: exports and prints stay in full colour.

Good to know

  • The editor opens with the rulers off, the guides visible, To Object and Smart on, and the rest of the snapping off. These settings are not saved with a project.
  • Guides, the grid and Xray never appear in an export or a print.

Next in the series: the Edit Path tab, with everything for nodes and segments.

Open the editor →